Stinky Styro Incy?

aart

Loving the herd life
Joined
Jan 12, 2017
Messages
120
Reaction score
104
Points
143
Location
SW Michigan
So does anyone else's incubator/hatcher get stinky 24-48 hours after chicks have begun to hatch?

Wonders if it's the current hatching gunk kept at 100F and high humidity or accumulative hatching gunk that seeps into the styrofoam and can't be washed/bleached out?
 

AlleysChicks

True BYH Addict
Joined
May 6, 2017
Messages
466
Reaction score
713
Points
203
Location
Southern Ohio
My first batch didn't, but round 2 did. I had 2 dead eggs though. Clean the bator then air it out for a few days. I took bleach wipes to the inside of mine and it doesn't smell now.
 

aart

Loving the herd life
Joined
Jan 12, 2017
Messages
120
Reaction score
104
Points
143
Location
SW Michigan
My first batch didn't, but round 2 did. I had 2 dead eggs though. Clean the bator then air it out for a few days. I took bleach wipes to the inside of mine and it doesn't smell now.
Have you heated it back up, used it to hatch again since cleaning out the stink?

I found it was the heat and humidity that made it stink. Once I pulled the plug and it cooled off, it didn't stink anymore. Cleaned it in water, then rinsed in a 10% bleach mix, then air dried in sun all day long.
Used it to hatch again starting last Wednesday, didn't start to stink until after the first few eggs hatched.
It reeks, can hardly stand to be in the room. Gack!

ETA: pretty sure there are no rotten eggs in there, weren't last time either.
 

AlleysChicks

True BYH Addict
Joined
May 6, 2017
Messages
466
Reaction score
713
Points
203
Location
Southern Ohio
I haven't hatched eggs in it since but I did use it as a brooder right after cleaning it for a yolk butt chick. It was in there for a week and a half. No bad smell.

Must be the hatching eggs then.
 

Wickedchicken6

Overrun with beasties
Joined
May 9, 2017
Messages
48
Reaction score
64
Points
76
Location
Pure crazyland
I stagger hatch so I washed my incubator in Dec 2015 and once in April/May 2016 when the 2-3 week old chicks in the cage "above" the incubator had a party and threw a huge amount of mess onto the incubator. (Um yeah, it's best NOT to have chicks above the incubator...it doesn't end well)
I would normally wash it at the end of hatching 2016 but didn't get to it this spring.:hide:hu
Once I set I don't stop setting until I'm done setting for the year. The incubator is never stopped.

I set my eggs on a paper towel in small baskets to hatch. It catches the majority of mess. I also don't leave the chicks in longer than it takes to mostly dry them OR unless they jump baskets. I can't handle the extra mess...lol. :sick:idunno

Forgot to add, it's a DIY Styrofoam incubator. I also forgot to add that this is only with my eggs. I stop and wash/Virkon it if I've brought new eggs in to hatch...for disease reasons. An extra pain but worth the time.
 
Last edited:

Dozclan12

Loving the herd life
Joined
Jan 28, 2014
Messages
190
Reaction score
180
Points
133
My bators don't always smell, but sometimes while hatching. I am one to snatch babies out after they have hatched. Real quick. I don't have the temp that high at hatch either. 99 is good. I actually have some in lock down at 97 right now.
I also use kitchen liner for them to hatch on, not so much of a mess hits the incubator. Just pick up the liner when done.
I do this to clean after each hatch.
I use half and half of water and bleach in a squirt bottle. I first rinse out the bator with hot water. Then I squirt it down with the bleach mix. Let it set for about 5 mins. is all. Then, rinse with hot water...then rinse with cold water.
Then, I put thermometer back in, set the lid on, and turn the heat up quite high. Around 110 degrees. Yep. I let it dry out like that. Works great.
 

aart

Loving the herd life
Joined
Jan 12, 2017
Messages
120
Reaction score
104
Points
143
Location
SW Michigan
Thanks for all the feedback!

@Dozclan12 reminded me of a couple things I didn't iterate earlier.
I do have paper towels under mesh covering almost all of bator bottom (except for corners where vent holes are) and pushed down into reservoirs, for better humidification and much easier clean up.
I also pull chicks once they are dry and too rowdy, I pull shells as soon as they are out of them.
This way most the hatching gunk gets pulled out too, some settles under mesh tho...I think that's what stinks.
I lift the windows to remove shells and chicks, instead of whole bator top so as to release less humidity and heat.

@Wickedchicken6 are you incubating and hatching in the same incubator....for, like, how many weeks on end??
 

Wickedchicken6

Overrun with beasties
Joined
May 9, 2017
Messages
48
Reaction score
64
Points
76
Location
Pure crazyland
@aart Um...yes I am. Incubating and hatching. In the same bator. :celebrate
You know...so I don't get bored or anything like that. :D =D I also set old eggs, just for the extra challenge...because we all need a challenge every so often in life. Yes, I'm totally serious...lol.
(This way, if I majorly screw up in my life, I can plead insanity...and it's not a stretch.);)

I set...
August 2015 to Octoberish 2015: I only had two hens...so I set approx. every two weeks
December 2015 to November 2016: With the clean up I mentioned above. (Darn party chicks!)
Disclaimer: No one said I was normal. :gig:hu
:weee
 
Top